Filter
Top Products
87
Record and Playback Your Performance
Record and Playback Your Performance
You can record over recorded performance data.
1.
Press the [Bwd] button or the [Fwd] button to
select the desired measure (bar) when you
start recording.
If you wish to start recording from the beginning of the
song, press the [Reset] button.
2.
Press the [Rec] button to enter recording-
standby mode.
The [Rec] button indicator will light, and the [Play/Stop]
button and the unrecorded track buttons will blink. The
track buttons that are already recorded will light.
3.
Press the button of the track you want to
record, so it’s blinking.
The existing performance data in the specified track will
be erased as recording takes place.
When the button for a track lights steadily, it means it won’t
be recorded.
4.
Press the [Play/Stop] button to start recording.
When you press the [Play/Stop] button, the metronome
will sound a two-measure count, and then recording will
begin.
As you listen to the performance song previously
recorded, record the Part into a new Track.
5.
Press the [Play/Stop] button to stop recording.
The track button for which performance data has been
recorded will be lit.
If you wish to re-record with different settings for voices,
tempo, part balance, erase the recorded song (p. 87) and
re-record again. If the Control track still contains data from
before you re-recorded, the volume or sounds may change
during playback.
If you wish to keep the existing Expression Pedal data, and
record only the panel operations, you can make settings to
prevent the operation of the Expression Pedal from being
recorded (p. 100).
If you wish to discard your recording and re-record from the
beginning, or if you wish to record a new performance, you
must erase the previously-recorded data.
1.
Press the [Display/Exit] button a number of
times to access the Composer screen.
2.
Press the [Load] and [Save] buttons
simultaneously.
The following message, asking you to confirm your
choice, will be displayed.
fig.08-10
To cancel the procedure, press the [Reset] button.
3.
If you are sure that you wish to erase the
song, press the [Rec] button.
Re-Recording
14, 5
3
2
NOTE
NOTE
NOTE
Erasing a Performance Song
1
2
3
AT-75_e.book 87 ページ ２００８年８月２１日 木曜日 午前１０時９分