Filter
Top Products
16
Before You
Start Playing
Before You Start Playing
Installing the Music Stand
fig.00-03.j
1. Using the supplied screws, attach the music stand
to the back of the KF-7 as illustrated.
Be sure to use the supplied screws for attaching the
music stand.
Turn the screws clockwise until they’re held in place–but
don’t tighten them yet.
2. Put the music stand between the screws and the
KF-7’s body.
3. While supporting the music stand with one hand,
secure it in place by turning the screws.
* When attaching the music stand, support it firmly with one
hand to make sure that you don’t drop it. Be careful, so you
don’t get your fingers pinched.
* Do not apply excessive force to the installed music stand.
4. To remove the music stand, support it with one
hand while loosening the screws.
* After removing the music stand, don’t forget to retighten the
screws.
Connect the Power Cord
924
* To prevent the inadvertent disruption of power to your unit
(should the plug be pulled out accidentally), and to avoid
applying undue stress to the AC adaptor jack, anchor the
power cord using the cord hook, as shown in the illustration.
Connecting Pedals
925
* Use only the specified expression pedal (EV-5; sold separately).
By connecting any other expression pedals, you risk causing
malfunction and/or damage to the unit.
1. Connect the supplied pedals (DP-8) to one of the
pedal jacks.
fig.00-03.j
When connected to the Damper jack, the pedal can be
used as a damper pedal.
When connected to Sostenuto, the pedal can be used as a
sostenuto pedal.
When connected to Soft, the pedal can be used as a soft
pedal.
* Unplugging a pedal cord from the unit while the power is on
may cause the pedal’s effect to be applied without stopping. Be
sure to switch off the power to the unit before attempting to
disconnect or connect a pedal cord.
DP-8
The DP-8 pedal controls the half damper function, a must for
authentic piano performances. Switching the DP-8’s function
switch to “Continuous” allows you to perform using the half
damper function.
Cord Hook
The cord of
the supplied AC Adaptor
To the AC Outlet
Pedal Switch
(DP-8)
Expression Pedal
(EV-5)
Roland
Damper Pedal jack
of the KF-7
Pedal Cord
Half Damper
Pedal
Switch Control