Filter
Top Products
17
Make settings for the divided pickup
3. Use [SELECT/VALUE ▼/▲] to specify the distance for
the selected string number.
* The example display shows that the 6th string is at a distance
of 10 mm.
fig.08
4. Repeat steps 2–3 for each of the remaining strings.
Adjusting the Pickup Sensitivity
for Each String (5 SENS)
Adjust the pickup sensitivity for each string according to
how the GK-2A divided pickup was installed.
* With the factory settings, this is set to “65.”
Make sure to set the divided pickup select switch to the
“SYNTH” position.
1. Press [PARAMETER ▼/▲] until “5” is shown (blink) at
the left of the display.
This selects “5 SENS.”
fig.10
2. Play any string on your guitar.
The string you played will be detected automatically,
and the string number will appear in the display.
At the same time, the TUNER indicator will show the
level. The indicators will light from left to right,
corresponding to the strength with which you played the
string.
* If you play the string too week or the pickup sensitivity is set
too low, the string number may not appear in the display.
fig.11-1
Display
Setting
10–30 10–30 mm
You can press [STRING] to specify the string number
directly.
Each press of the button takes you to the next string
number, from string 1 through string 6.
(The string number is indicated by a dot.)
If you play a string other than the one indicated by the
dot, the display switches to the number of the string that
was played.
3
1