Filter
Top Products
19
Make settings for the divided pickup
Specify the function of the
S1/S2 switch (7 S1/S2)
* With the factory settings, this is set to “1 PICKUP SEL.”
1. Press [PARAMETER ▼/▲] until “7” is shown (blink) at
the left of the display.
This selects “7 S1/S2.”
fig.13
2. Use [SELECT/VALUE ▼/▲] to specify the function of
the S1/S2 switches.
Get the corresponding number to appear at the right of
the display.
* The S1/S2 switch is disabled while settings are being made.
* The example display shows that the S1/S2 switch is set to
“1 PICKUP SEL.”
Changing the Switching Direction of S1 and S2
when PICKUP SEL Is Selected
Normally, the COSM GUITAR pickups are switched by
pressing the S1 switch for MIC → F, and pressing the S2
switch for F → MIC, but by switching on the POWER
switch while holding down [GK] and [NUMBER ▲], you
can set this so the directions are reversed. In this case,
the COSM GUITAR PICKUP “R” indicator will blink.
To return to the ordinary state, switch on the POWER
while holding down [GK] and [NUMBER ▼].
In this case, the COSM GUITAR PICKUP “F” indicator
will blink.
Setting the Output Level of
the COSM Guitar (8 LEVEL)
You can adjust the balance between the output level of the
divided pickup and the output level of the guitar pickup.
* With the factory settings, this is set to “0.”
Make sure to set the divided pickup select switch to the
“SYNTH” position.
1. Press [PARAMETER ▼/▲] until “8” is shown (blink) at
the left of the display.
This selects “8 LEVEL.”
fig.14
2. Press [SELECT/VALUE ▼/▲] to adjust the balance
(– 5–5) between the COSM guitar sound and the normal
guitar sound.
Negative (–) settings will decrease the COSM guitar
sound, and positive (+) settings will increase it.
Move the select switch of the divided pickup between
“SYNTH” and “GUITAR,” and adjust the volume
balance while playing your instrument in each position.
Display
Setting
1
PICKUP SEL:
Switching the pickup of
COSM guitar
2 NUMBER: Number up/down
3 BANK: Bank up/down
4 TUNER: Tuner on/off
1
2
1
2