Filter
Top Products
24
About Patch
Saving your modifications in
a patch (Write)
If you wish to save the modifications you have made, you
must store them in a user patch. This operation is called
“Write.”
All settings except for the MASTER knob can be saved.
* If you used the foot switch to turn the effect on/off (p. 36), that
setting will also be remembered.
1. When you finish modifying (editing) the settings, press
[WRITE], getting its indicator to blink.
fig.46
2. Use [BANK ▼/▲] and [NUNBER ▼/▲] to select the
user patch in which your settings will be stored.
* Patch numbers can also be selected using the direct number
buttons.
3. To write the settings, press [WRITE].
While Write is being executed, the indicator flashes
rapidly.
When the data has been written, the indicator will go
out, and the writing destination user patch will be
displayed.
If You Want to Cancel a Write Operation
in Progress
Press either [TUNER], [VARIATION/EDIT], [GK],
[SYSTEM], or [PRESET/USER].
The values are left as is, and the Write operation is
cancelled.
Manual Mode
If you wish to play the sound specified by the current
settings of the knobs (rather than the sound memorized in
the patch), switch to Manual mode.
◆ To select Manual mode, press [MANUAL], lighting its
indicator.
In Manual mode, the display will show the following.
fig.19
After this, when one of the buttons or knobs is used, the
settings for that control appear in the display.
* When the settings for CAPO (p. 27) or DELAY TIME (p. 32)
are showing in the display, you can change the settings value
directly by pressing the [SELECT/VALUE ▼/▲].
Press [A/B] to exit Manual mode and return to the
settings of the selected patch.
* The [MANUAL] indicator will also go out, and Manual mode
will be exited if you press one of the [PRESET/USER],
[BANK ▼/▲], [NUMBER ▼/▲] or Direct Number buttons.
◆ If you once again enter Manual mode, the previous
settings used in Manual mode are called up (except for
knob settings).
◆ If you hold down the Direct Number button that is lit
and press [MANUAL] to select Manual mode, settings
from the previous patch settings (other than the knob
settings) will remain active.
2
1,3
2