Filter
Top Products
48
Appendices
Changing the MIDI Settings
When using MIDI to control the VGA-7, you can change the settings for the MIDI parameters as needed.
1. While holding down [SYSTEM], turn on the POWER switch.
2. Use [PARAMETER ▼/▲] to select MIDI parameters.
3. Press [SELECT/VALUE ▼/▲] to set the value.
4. Press either [TUNER], [VARIATION/EDIT], [GK], or [SYSTEM] to stop the operation.
* If two or all of “6 TUNER,” “d PRESET/USER,” and “E MANUAL/MEMORY” are set to the same controller number, control will be
given priority in the order of 1: 6 TUNER, 2: E MANUAL/MEMORY, and 3: d PRESET/USER, and control of the remaining
parameter(s) will be disabled.
With the foot volume and the WAH controller number both set to the same number, you can use a single expression pedal to
control both the volume and the wah effect, the pedal acting as a wah pedal when the WAH effect is on, and as a volume
pedal when the wah effect is off.
Parameter No. Value
Factory
Setting
Setting
for FC-200
1 MIDI CH (Setting for MIDI channel) 1–16 1 1
2 OMNI (Setting for Omni mode) On, OFF On On
3 DEVICE ID (Setting for Device ID) 1–32 1 1
4 Foot Volume (Controller No.) 1–31, 64–95 7 7
5 WAH (Controller No.) 1–31, 64–95 7 7
6 TUNER (Controller No.) 1–31, 64–95 80 80
7 EFX (Controller No.) 1–31, 64–95 65 65
8 DELAY (Controller No.) 1–31, 64–95 66 66
9 CHORUS (Controller No.) 1–31, 64–95 67 67
A REVERB (Controller No.) 1–31, 64–95 68 68
b TAP (Controller No.) 1–31, 64–95 69 69
c CAPO (Controller No.) 1–31, 64–95 70 70
d USER/PRESET (Controller No.) 1–31, 64–95 75 75
E MANUAL/MEMORY
(Controller No.)
1–31, 64–95 64 76