Filter
Top Products
42
System setting
3. Press [WRITE] to send the data.
The following display will appear while the data is being
transmitted.
fig.53
* When ALL/PATCH (ALL) is selected, it takes approximately
40 seconds to complete transmission of the data.
4. When the transmit data selection display reappears,
press [SYSTEM] to end the procedure.
Sending Only the Divided Pickup Settings and
System Settings
1. While holding down [GK] and [SYSTEM], turn on the
power switch.
[WRITE] indicator will blink, the following will appear
in the display.
fig.98
* To cancel transmission, press either [TUNER],
[VARIATION/EDIT], [GK], or [SYSTEM].
2. Press [WRITE] to send the data.
The following display will appear while the data is being
transmitted.
fig.99
When transmission is finished, the patch or manual
mode that was selected at the time the POWER switch
was turned off will be selected.
MIDI OUT
Parameter Number: 8 FUNCTION
Here’s how to change the function of the MIDI OUT
connector to MIDI THRU.
* At the factory settings, this is set to “MIDI OUT.”
Display Setting
1 OUT:
The connector will function as MIDI OUT.
2 THRU:
The connector will function as MIDI THRU.
MIDI messages received at MIDI IN will be re-
transmitted without change.
blink
blink