Filter
Top Products
20
fig.daw01.eps
This section controls SONAR’s track or bus parameters.
1.
Track selection button
Use this button to select the track (or bus) to control.
[SHIFT] + track selection buttons
Press this key combination to switch the current strip between the track and the bus.
Track selection button + [VALUE] knob
Press and hold the track selection button while you turn the [VALUE] knob to select the track to control.
2.
[ASSIGN] button
Press this button to switch the parameter assigned to the [VALUE] knob.
The assigned parameter will depend on the track (or bus) you’re controlling. For details, refer to SONAR’s
online Help.
The currently assigned parameter is displayed on the screen. (See p. 19.)
[SHIFT] + [ASSIGN] buttons
When you press this key combination, the [ASSIGN] button flashes and you can use the [VALUE] knob to change the
current time (jog/shuttle mode).
To restore the display, press the [ASSIGN] button.
3.
[VALUE] knob
Use this knob to change the value of the current parameter.
Channel strip section
VS-100_r_e.book 20 ページ ２００９年３月２５日 水曜日 午前９時３４分