Filter
Top Products
40
Turning the power on
* Once the connections have been completed (p. 38), turn on power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices.
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit
will operate normally.
* Always make sure to have the volume level turned down before switching on power. Even with the volume all the way
down, you may still hear some sound when the power is switched on, but this is normal, and does not indicate a
malfunction.
1.
Turn the SONAR V-STUDIO 100’s [MAIN MIX] knob and the Headphone [VOLUME] knob to the
minimum.
fig.Vol-Min.eps
2.
If the SONAR V-STUDIO 100 is connected to a computer, turn on the power of your computer.
3.
Turn on the power switch of SONAR V-STUDIO 100.
fig.P-ON.eps
4.
Turn on the power of the monitor speaker.
* To protect its circuits, the SONAR V-STUDIO 100 does not operate for a while after you turn the power on.
VS-100_r_e.book 40 ページ ２００９年３月２５日 水曜日 午前９時３４分