Filter
Top Products
Using the devices
17
Using the devices
To establish a transmission link, proceed as follows:
1. Switch the receiver on.
2. Switch a transmitter on.
The transmission link is established and the receiver’s RF level display “RF” reacts.
If you cannot establish a transmission link between transmitter and receiver:
̈ Make sure that transmitter and receiver are set to the same frequency bank and to the
same channel.
̈ If necessary, read the chapter “If a problem occurs ...” on page28.
Switching the devices on/off
EM 100 receiver
To switch the receiver on:
To switch the receiver to standby mode:
̈ If necessary, deactivate the lock mode (see page 21).
It is vital to observe the following notes:
̈ Make sure that the desired frequencies are listed in the enclosed frequency
information sheet.
̈ Make sure that the desired frequencies are approved and legal in your country
and, if necessary, apply for an operating license.
ᕨ ᕨ
º º
0
0
00 G3
MHz
SET
²
̈ Briefly press the STANDBY button ².
The receiver switches on and the “Receiver Parameters” standard display appears.
̈ Keep the STANDBY button ²
pressed until “OFF” appears on the display panel.
When in the operating menu, pressing the STANDBY button ² will cancel your entry
(ESC function) and return you to the current standard display.