Using the devices
20
To switch the radio microphone on and to deactivate the RF signal on switch-on (offline
operation):
To activate the RF signal:
Synchronizing a transmitter with the receiver
You can synchronize a suitable transmitter of the ew 100 G3 series with the receiver. During
synchronization, the following parameters are transferred to the transmitter:
To transfer the parameters:
̈ Switch the transmitter and the receiver on.
̈ Press the button ³ on the receiver.
“Sync” appears on the display panel of the receiver.
̈ Place the infra-red interface of the transmitter (see page 7 and 9) in front of the infra-
red interface of the receiver ·.
The parameters are transferred to the transmitter. When the transfer is completed, “ ”
appears on the display panel. The receiver then switches back to the current standard
display.
To cancel the transfer:
̈ Press the STANDBY button on the receiver.
̈ Press the ON/OFF button ¹ until “RF Mute On?” appears on the display panel.
̈ Press the multi-function switch ¸.
The transmission frequency is displayed but the radio microphone does not
transmit an RF signal. The transmission icon ብ is not displayed.
Use this function to save battery power or to prepare a radio microphone for use
during live operation without causing interference to existing transmission links.
̈ Briefly press the ON/OFF button ¹.
“RF Mute Off” appears on the display panel.
̈ Press the multi-function switch ¸.
The transmission icon ብ is displayed again.
ON/OFF
MHz
543.200
ew100 G3
MUTE
P
AF
ብ
ON/OFF
Setting Transferred parameters
“Frequency Preset” Currently set frequency
“Name” Freely selectable name currently set on the receiver
“Pilot Tone” Current pilot tone setting of the receiver (“Inactive”/“Active”)
·
³
·
³
