Filter
Top Products
26
MZ-R909
75. Adjust with the [VOL+] key (adjusted value up) or [VOL--]
key (adjusted value down) so that the adjusted value becomes
0E.
76. Press the X key.
(1020 is blinking)
77. Press the [VOL+] key once to change the blinking portion to
1021.
78. Press the x key.
(00 is blinking)
79. Adjust with the [VOL+] key (adjusted value up) or [VOL--]
key (adjusted value down) so that the adjusted value becomes
F0.
80. Press the X key.
(1021 is blinking)
81. Press the [VOL+] key once to change the blinking portion to
1022.
82. Press the
x key.
(00 is blinking)
83. Adjust with the [VOL+] key (adjusted value up) or [VOL--]
key (adjusted value down) so that the adjusted value becomes
B0.
84. Press the X key.
(1022 is blinking)
85. Press the [VOL+] key once to change the blinking portion to
1023.
86. Press the x key.
(00 is blinking)
87. Adjust with the [VOL+] key (adjusted value up) or [VOL--]
key (adjusted value down) so that the adjusted value becomes
E1.
88. Press the X key.
(1023 is blinking)
023 10200E
Remote commander LCD display
0E
: Adjusted value
023 102100
Remote commander LCD display
00
: Adjusted value
023 1021F0
Remote commander LCD display
F0
: Adjusted value
023 102200
Remote commander LCD display
00
: Adjusted value
023 1022B0
Remote commander LCD display
B0
: Adjusted value
023 102300
Remote commander LCD display
00
: Adjusted value
89. Press the [VOL +] key to change the blinking portion to 102C,
and press the [DISPLAY] key on the remote commander for
several seconds (about 3 seconds) to exit the patch data write
mode and display as below.
90. Press the [VOL+] key to display as below.
91. Press the [DISPLAY] key on the remote commander for several
seconds (about 3 seconds) to activate the patch data write mode.
(The following display will appear where 00 is blinking)
92. Adjust with the [VOL+] key (adjusted value up) or [VOL--]
key (adjusted value down) so that the adjusted value becomes
10.
93. Press the X key.
(102C is blinking)
94. Press the
[VOL+] key twice to change the blinking portion to
102E.
95. Press the x key.
(00 is blinking)
96. Adjust with the [VOL+] key (adjusted value up) or [VOL--]
key (adjusted value down) so that the adjusted value becomes
9F.
97. Press the X key.
(102E is blinking)
98. Press the [VOL+] key once to change the blinking portion to
102F.
99. Press the x key.
(00 is blinking)
023 1023E1
Remote commander LCD display
E1
: Adjusted value
023 Patch09
Remote commander LCD display
09
: Adjusted value
023 ****0A
Remote commander LCD display
0A
: Adjusted value
023 102C00
Remote commander LCD display
00
: Adjusted value
023 102C10
Remote commander LCD display
10
: Adjusted value
023 102E00
Remote commander LCD display
00
: Adjusted value
023 102E9F
Remote commander LCD display
9F
: Adjusted value
023 102F00
Remote commander LCD display
00
: Adjusted value