Filter
Top Products
18
Names and Functions of Controls on Screen
PROJECTOR CONTROL Block
You can establish various setups to control a projector, refer to
“How to Control the Display from the SRP-X700P” of the SRP-
X700P Operating Instruction.
q; I/F TYPE
The connection method that corresponds to the projector
selected by qaPROJECTOR PROTOCOL setup box, is
displayed.
qa PROJECTOR PROTOCOL setup box
Selects a projector that is to be connected to the PROJECTOR
CONTROL terminal.
When USER DEFINE is selected, the projector is controlled
by the communication protocol set on the USER DEFINE
screen.
Once the communication protocol for the projector has been
set on the USER DEFINE screen, the projectors not supported
by default can be connected.
When USER DEFINE is selected, 0 I/F TYPE is set in RS-
232C.
z When USER DEFINE is selected and qf USER DEFINE
button is clicked, the communication protocol with
projector can be set.
qs REMOTE POWER ENABLE button
You can interlock the power on/off control of the projector
with the POWER button of the SRP-X700P. The REMOTE
POWER ENABLE button lights in green when interlocked.
<Setting FUNCTION><Setting parameter>
Click the PARALLEL
INPUT FUNCTION
setup box.
Click the dropdown list
to display parameters.
Select a parameter.Select the desired
FUNCTION.
Completed.
Setting Parameters of PARALLEL I/O
Procedure for setting FUNCTION on the REMOTE screen
Example: The procedure for setting the LINE4 input to “A” when PARALLEL INPUT 1 is set to ON:
* For the contents of each item, perform the same step referring to the table shown on page 19.
qd SIGNAL DEFINE setup box
Select the video signal format for each channel of the LINE 4
input, that is sent to projector.
• LINE4A to LINE4C: You can select VIDEO, S-VIDEO or
LAN.
• LINE4D to LINE4F: You can select RGB, COMPONENT
or LAN.
When you select LAN, the LAN input connector of a projector
is automatically selected.
Note
• When you connect a projector with the Control S, you
cannot mix the RGB signal with the COMPONENT signal.
• When you select LAN, select an appropriate projector
supporting LAN from “How to Control the Display from the
SRP-X700P” of the SRP-X700P Operating Instruction.
qf USER DEFINE button
Shows the USER DEFINE screen in the PROJECTOR
PROTOCOL setup box, to set the communication protocol
used when USER DEFINE is selected.
When index is set in the USER DEFINE screen, the index is
displayed on the button.
If USER DEFINE is not selected in the PROJECTOR
PROTOCOL setup box, clicking is disabled.