Filter
Top Products
20
USER DEFINE Screen
Use this screen to set the communication protocol when USER DEFINE is selected in the PROJECTOR
PROTOCOL setup box.
When USER DEFINE is selected, the projector is connected to the PROJECTOR CONTROL RS-232C terminal.
Once the communication protocol between the SRP-X700P and projector has been set, the projectors not supported by default can be
connected.
Note
The above-described setup does not guarantee operation of all projectors.
Names and Functions of Controls on Screen
1 File menu
The setups that have been entered in the USER DEFINE
screen can be saved and read to and from the setup file (∗.pj7).
Open : Opens an already existing projector setup file.
Save : Overwrites and saves the projector setup file.
Save as : Saves the projector setup file as a different name
which is to be specified.
Note
The screen setup that can be saved and read as the projector
setup file, is the only USER DEFINE screen setup. The other
screen setups cannot be saved nor read.
If you want to save and read all of the USER DEFINE screen
setups and other screen setups, see the description of the File
menu under the “Common operation section” on page 6.
2
1
3
2 EXIT button
Closes the USER DEFINE screen.
3 Index setup
Enters the projector index.
You can enter up to 8 alphanumeric characters.
The index set here is displayed on the USER DEFINE button
of the REMOTE screen.