Filter
Top Products
21
Port setup
Sets the communication conditions between the SRP-X700P and projectors.
4 BITS PER SECOND setup box
Sets the baud rate.
Select the desired speed to 9600, 19200, or 38400 bps
depending on the baud rate of the projector.
4
5
5 PARITY BIT setup box
Sets the parity bit.
Select NONE, ODD, or EVEN depending on the
communication data specifications of the projector.
PROJECTOR POWER ON setup
Sets the command to turn on the projector power and sets the wait time after the command has been sent.
6
8
7
6 COMMAND setup box
Sets the command to be sent from the SRP-X700P to the
projector to turn on the projector power.
Enter the command as a hexadecimal number using numbers 0
to 9 and letters A to F.
The maximum length of the command is 24 bytes.
7 WAIT setup box
The projector stops receiving any command after the power on
until its operation has stabilized.
Therefore, enter the wait time before sending the next
command after the power-on command has been sent from the
SRP-X700P to the projector.
The wait time can be set in the range of 10 to 200 seconds in
10-second steps.
8 TEST button
Tests the PROJECTOR POWER ON command.
PROJECTOR POWER STANDBY setup
Sets the command to put the projector in the power standby state and sets the wait time after the command has been sent.
9
qa
0
9 COMMAND setup box
Sets the command to be sent from the SRP-X700P to the
projector to put the projector in the power standby state.
Enter the command as a hexadecimal number using numbers 0
to 9 and letters A to F.
The maximum length of the command is 24 bytes.
q; WAIT setup box
The projector stops receiving any command after it has entered
the power standby state until the standby operation is
complete.
Therefore, enter the wait time before sending the next
command after the power-standby command has been sent
from the SRP-X700P to the projector.
The wait time can be set in the range of 10 to 200 seconds in
10-second steps.
qa TEST button
Tests the PROJECTOR POWER STANDBY command.