Filter
Top Products
68
12.6. Protect Settings
Operation misses can be avoided by protecting front panel-mounted key operations.
Tips
• To make subsequent protections valid when the power is ON after the initial Protect function settings, save
the configuration (p. 60). (However, if the Protection function is enabled in the way described below, the
configuration save needs not be performed because the latest configuration including the Protection function
settings are automatically saved at the moment of the key operation.) Settings are saved as system data,
and setting status is maintained even if the preset memory is recalled.
• Control operations can be performed either by way of the RS-232C port or the remote control module even
when in protection mode.
• Configuration can also be saved by pressing the Setting knob at this screen.
[UTY] PROTECT
UNLOC
K
RS-232C port
settings (p. 70)
When using the D-981, D-983, or D-984VC:
Contact input/output settings (p. 65)
When not using the D-981, D-983, or D-984VC:
NOM attenuation settings (p. 64)
Individual Function Key
Protect setting screen
(Refer to the next page.)
• Confirm protect status.
UNLOCK: Disables the Protect function. The Protect function can be set while
unlocked.
LOCK: Enables the Protect function, and validates the Protect function settings.
[Enabling and disabling the Protect function]
Press the Setting knob while holding down the
Utility key to enable the Protect function and
lock the system. (The System Lock indicator
lights.) To release the lock and disable the
Protect function, press the Setting knob again
while holding down the Utility key. (The System
lock indicator extinguishes.)
Note
Both the system lock and unlock operations
automatically save the configuration.
UTILITY
PRESET
PARAMETER
DIGITAL MIXER model D-901
1
2
ON
6
37
5
48
PRESET
PUSH-ENTER
CHANGE
LOCK
ENTRY SECTION
System lock indicator
ON
MIC BUS
FBS
EFFECT
UTILITY
8
7
6
5
1
2
3
4
5
612
11
10
9
8
7
PRESET
INPUT OUTPUT
PARAMETER
DIGITAL MIXER model D-901
1
2
ON
POWER
OFF
ON
6
37
5
48
PRESET
PUSH-ENTER
CHANGE
LOCK
4
3
2
1
ENTRY SECTION
ON
SEL
+12dB
+6dB
0dB
-6dB
PEAK
-40dB
-20dB
-12dB
0N SIG SEL
SEL SIG 0N 0N SIG SEL
CURSOR
ALL
CHG PARAM *UTILITY
SELECT
LOAD
INPUT OUTPUTPRESET EFFECT
*
Bus assignment operations by way of the Input and Output channel selector keys are also locked
and disabled.
[Keys that can be protected]