Filter
Top Products
85
19. PARAMETER SETTING ITEMS AND SETTING RANGES
Note: Underlined parameters are factory-preset.
[Input and Output/Trim Settings]
[D-921F or D921E settings (enabled when the module is mounted)]
Setting Item Setting Range
Phantom Power ON, OFF
PAD (Input Sensitivity) –50, –36, –10, +4 dB
Setting Item Setting Range
Input Channel Gain –∞ to +10 dB
Input Trim Gain –15 to +15 dB (0 dB
), 0.1 dB steps
Input Trim Polarity NORMAL, INVERSE
Input Channel Group Trim Gain –∞ to +10 dB, 0.1 dB steps
Output Channel Gain –∞ to +10 dB (0 dB)
Output Channel Group Trim Gain –∞ to +10 dB, 0.1 dB steps
[High-Pass Filter Settings]
Setting Item Setting Range
Cutoff Frequency 20 Hz to 20 kHz (60 Hz
), 1/24 octave steps
Slope 12 dB/oct
Q 0.500 – 2.563 (0.707) (51 points)
ON/OFF ON, OFF
[Equalizer Settings]
Setting Item Setting Range
Gain –15 to +15 dB (0 dB), 0.1 dB steps
Center Frequency 20 Hz to 20 kHz (Low: 630 Hz, High: 1.25 kHz), 1/24 octave steps
Q 0.267 – 69.249 (4.318
) (96 points)
ON/OFF ON
, OFF
[Compressor Settings]
Setting Item Setting Range
Threshold Level –20 to +20 dB (0 dB), 1 dB steps
Ratio 1:1, 2:1, 3:1, 4:1, 8:1, 12:1, 20:1, ∞:1
Attack Time 0.2, 0.5, 0.7, 1.0, 1.5, 2, 3, 5, 7, 10, 20, 50, 70, 100, 120, 150, 200,
250, 300, 500, 700 ms
1, 2, 3, 5 s
Release Time 10, 20, 50, 70, 100, 120, 150, 200, 250, 300, 500, 700 ms
1, 2, 3, 5 s
Gain –∞ to +10 dB (0 dB), 1 dB steps
ON/OFF ON, OFF
[D-936R settings (enabled when the module is mounted)]
Setting Item Setting Range
Line Input Mode MIX ALL, SELECT
[Compressor/Auto-Leveler Mode Settings]
Setting Item Setting Range
Compressor/Auto-Leveler Mode COMP
, LEVELER