Filter
Top Products
Before UsingBasics SectionAppendix Getting StartedReference
01X Owner’s Manual
143
Display Messages
Display Messages
Messages Information
*** SURE? This prompt asks if you want to execute the operation, or change the setting (Final confirmation).
---- (Channel number “flashes” alternately with “----”) These channels cannot be used while 01X is set to 96kHz/88.2kHz operation.
Do you want to initialize backup data? This prompt asks if you want to initialize the backup data (page 86).
ERROR: Backup Data Crashed!!
Do you want to initialize backup data?
Because the power was turned off while data was being written to Flash ROM (during a “Please
keep power on” message), the backup data must be initialized (page 86). The prompt asks if you
want to initialize the backup data.
EXECUTING BACKUP. PLEASE KEEP POWER ON...
Never attempt to turn off the power while data is being written to Flash ROM. Turning the power off
in this state results in loss of all user data and may cause the system to freeze (due to corruption of
data in the Flash ROM).
INCORRECT WORDCLOCK!
An inappropriate wordclock is being received from the connected device to which you are synchro-
nizing (page 92).
Initializing backup data, please keep power on ...
The Factory Set operation is being executed. Never attempt to turn off the power while data is being
written to Flash ROM. Turning the power off in this state results in loss of all user data and may
cause the system to freeze (due to corruption of data in the Flash ROM).
LIBRARY: CATEGORY CONFLICT!
The channel categories (e.g., Input , Aux Out, etc.) of the original recall/store destination do not
match (page 103).
LIBRARY: FOR EFFECT1 ONLY! Not available for Effect 2
LIBRARY: INVALID CHANNEL! You can recall or store settings for this channel.
LIBRARY: NO DATA! The selected region does not contain data.
LIBRARY: PROTECTED! Can’t save, erase, or edit the title because the song is protected.
LIBRARY: READ ONLY! Can’t save, erase, or edit the title because the song is read-only.
mLAN MASTER NOW! This operation cannot be performed because the 01X is in mLAN Master mode (page 92).
mLAN SLAVE NOW! This operation cannot be performed because the 01X is in mLAN Slave mode (page 92).
MLAN1/4/5: TX BUFFER FULL!
MLAN1/4/5: RX BUFFER FULL!
Failed to process the MIDI data because too much data was received/transmitted at once.
NOT AUTO WORDCLOCK MODE NOW! The mLAN auto wordclock setting is invalid (page 92).
NOT DEFINED. Not available for this channel.
RELEASE PAIR? This prompt asks if you want to release the pair setting (page 102).
SYSTEM BACKUP OK? This prompt asks if you want to execute System Backup (page 86).
UNLOCK (NO SIGNAL) NOW! This cannot be selected as the wordclock source (page 92).