Filter
Top Products
01X Owner’s Manual
Function Tree/Function List
99
Before UsingBasics SectionAppendix Getting StartedReference
■ EQ LIBRARY (Common to 4 bands) (Selected Channel only)
(This can be called up by pressing the same EQ button twice in a row. For example: [EQ LOW] → [EQ LOW])
q – r
01 – 200
(Library number)
Determines the Library number. Preset EQ numbers (01 – 40; see page 115)
are indicated by asterisks (*) in the display and cannot be changed.
No 36
z – v (Title Edit)
Determines the title (name) of the EQ Library.
No 41
b RECALL
For calling up the selected EQ Library. The confirmation prompt can be
turned on/off as desired. (See “Recall Confirmation” on page 95.)
Ye s 5 4
n STORE
EQ settings are stored to internal memory in the EQ Library. Up to 160 set-
tings can be stored. The confirmation prompt can be turned on/off as desired.
(See “Store Confirmation” on page 95.)
•Any and all data in the Store destination will be lost when executing the
Store operation. Make sure to save and archive important data to com-
puter using the Studio Manager program (page 9).
Ye s 6 5
m CLEAR
This deletes the selected EQ Library.
Ye s
PAN [INTERNAL] → ([SELECTED CHANNEL]) → [PAN]
PAN/BALANCE
q
– i
(q)
L63 – CENTER – R63
Enables adjustment of the pan setting of the signals routed from the Input
Channels to the Stereo Bus. Pressing the [SEL] button of ST IN channels
repeatedly toggles between the left and right channels, for independent opera-
tion. You can also apply the pan setting to a pair of Bus channels. When the
Stereo Out (ST) is selected, it is used to set the balance.
No !1
RECBUS (REC bus assign)
q
– i
(e)
ON/--
When this is set to on, the corresponding input channel signal is sent to the
Rec Bus.
No @1
ST-BUS (Stereo bus assign)
q
– i
(r)
ON/--
When this is set to on, the corresponding input channel signal is sent to the
Stereo Bus.
No @1
PHASE
q
– i
(t)
NORMAL/REVERS
Switch the corresponding Input Channel phase. NORMAL indicates normal
phase, and REVERS indicates reversed phase. You can set the phase sepa-
rately for ST IN channel L/R or each channel in a channel pair. Pressing the
[SEL] buttons repeatedly toggles between L and R.
No 21 y
ON/OFF (Selected Channel only)
(u) ON/OFF
Determines whether the channel is on or off. The channel is muted with the
Off setting. This works in unison with the [ON] button on the panel.
No o
LEVEL (Selected Channel only)
(i)
-
∞
– +6.0
(BUS/AUX/ST:
-
∞
– +0.0)
Enables adjustment of the input level of the Input Channel signal and the out-
put level of the Output Channel. When the channel knob 8 is pressed, the level
is set to nominal (0dB). This works in unison with the channel fader on the
panel.
No !0
Knob
Function name/
settings
Explanation Prompt
Related
pages
Block
diagram
[PAGE SHIFT] + DISPLAY [ / ]
[PAGE SHIFT] + DISPLAY [ / ]
[PAGE SHIFT] + DISPLAY [ / ]
[PAGE SHIFT] + DISPLAY [ / ]
[PAGE SHIFT] + DISPLAY [ / ]