Filter
Top Products
21
M-Module Field Wiring Information
The following section provides a brief, summary of the field wiring for each Hewlett-Packard M-module. It
includes a connector pin-out table, a simplified schematic, and a connector drawing. For additional information
about a specific M-Module, refer to the respective M-Module’s User’s Manual.
Caution Do not exceed the voltage and current specifications for the individual modules.
Caution All installation, wiring, and configuration procedures are to be done with power
DISCONNECTED from the VXI mainframe and power DISCONNECTED from any
external wiring/cabling.
WARNING To prevent electric shock, tighten all faceplate and mounting screws when
installing M-Modules on the Carrier and the field wiring connector mounting
screws.
Assembling the M-Module Field Wiring Connector
Most M-Modules come supplied with a 44-pin connector and matching hood with strain relief (kit part number
E2251-01203). You must supply your own cable. The figure on the next page shows how to assemble the
connector and hood.
Note Do not assemble the hood to the connector for the two internally-mounted M-Modules. Strain
relief can be provided by wire ties through holes in the Carrier.