Filter
Top Products
NXC-M Master Card
8
NetLinx Master Cards and Modules
Rear panel components
FIG. 4 shows the rear panel components of the NXM-M Master Card.
Installing an (optional) NCP-E Ethernet Card
The NXC-M Master Card has an expansion slot (port card connector) that allows you to mount an
NCP-E Ethernet port card as a daughter board. Installing an NCP-E upgrades the NXC-M to an
NXC-ME Master/Ethernet card.
To mount the optional NCP-E port card to the NXC-M:
1. Remove the existing rear plate from the NXC-M, as shown in FIG. 5.
2. Install the new rear plate (included with the NCP-E), as shown in FIG. 6.
FIG. 4 NXM-M Master Card (shown mounted in a NXS-MHS Module - rear view)
FIG. 5 Removing the existing rear plate
Master
NXC-M
CTS
PROGRAM
GND
PWR
12VDC
RTS
AXM
AXP
PWR
AXlink
GND
TX
RX
ICSNet
OUT
ICSHub
IN
ICSHub IN/OUT connectors/LEDs
ICSNet connectors/LEDs
PROGRAM port connector
AXLink connector
AXLink status LED (green)
12 VDC power supply connector
NXC-M