Barco DX-700 Manual

A SERVICE OF

next previous

DX-700 • User’s Guide • Rev 02 49

2. Hardware Orientation

DX-700 Rear Panel

kkf=lìíéìí=jçÇìäÉ

The figure below illustrates the DX-700’s NNI Output Module.

Figure 2-9. DX-700 NNI Output Module

1) Thumb Screws

Two captive, spring-loaded Thumb Screws are provided to secure the module

into the DX-700 chassis.

2) Latches

Two Latches are provided to ensure precise module insertion and extraction.

Care is required when inserting or removing modules. Refer to the “

Module

Insertion and Extraction” section on page 57 for instructions.

3) NNI Outputs

Three HDMI-type connectors are provided for NNI Outputs, which connect to new

LED products such as NX-4. Each output can drive one attached display from any

portion of a selected source image, and each output is limited to a maximum

resolution of 1024 x 768.

1) Thumb Screws 3) NNI Outputs

2) Latches

LED OUT 1 LED OUT 2 LED OUT 3

2

2

1

1

3