Filter
Top Products
DX-700 • User’s Guide • Rev 02 87
4. Operation
Using the Setup Wizard
15. The Output Position Menu enables you to precisely adjust image size and
position until all four sides of the raster box are visible.
Figure 4-15. Setup Wizard: Output Position Menu (sample)
To adjust the raster box (in pixels):
~ For DVI tiles, use the {Horizontal Position}, {Vertical Position},
{Horizontal Size} and {Vertical Size} controls.
~ For NNI tiles, use the {Horizontal Size} and {Vertical Size} controls.
The other sliders do not appear.
16. Press {Next} to display the Output Selection Menu again. Several options are
available:
~ To set up any remaining outputs, select an output and repeat the setup
procedure from step
7.
~ If you have only one output set up, press {Next}. Please continue with
step
17.
~ If two or more outputs have been set up, press {Display}. Please
continue with step
18.
17. (One output is set up) If there are remaining outputs to set up, you will be
prompted to continue. If you elect to continue, and if you have pre-selected the
“reduced” or “minimum” delay modes on the
Reduced/Minimum Delay Menu,
you will be prompted to assign the current output as the delay output.
Figure 4-16. Select current output as the delay mode output