Filter
Top Products
DX-700 • User’s Guide • Rev 02 55
2. Hardware Orientation
Module Installation and Configuration
jçÇìäÉ=fåëí~ää~íáçå=~åÇ=`çåÑáÖìê~íáçå
The following topics are discussed in this section:
• Module Configuration Rules
• Module Insertion and Extraction
• Storing Spare Modules
jçÇìäÉ=`çåÑáÖìê~íáçå=oìäÉë
DX-700 input and output modules can be configured in a variety of ways, but important sets
of rules apply to their placement. As a prerequisite, ensure that you are familiar with the
“
Understanding Banks” section, on page 24 in Chapter 1.
Please note the following important “module” rules:
• In the most basic of DX-700 “single bank” configurations, you must have at least
one input module and one output module — to route video to an LED wall.
• As you face the rear of the chassis, the right-most module within the entire Input /
Output Section must always be an Output Module, and it must always be right-
justified against the System Module.
Figure 2-12. Right justification of Output Modules against the System Module
• Within any bank, all modules must be adjacent to each other — with no blank
panels in-between, and all
Output Module(s) are always right-justified.
Figure 2-13. Adjacent modules within a bank
Blank
Blank
Blank
Input
Input
Input
Output
System
Power
Input
Input
Input
Output
System
Power
Blank
Blank
Blank
Correct Justification Incorrect Justification
Input / Output Section
Input / Output Section
Blank
Input
Output
System
Power
Input
Output
Blank
Blank
Correct Justification Incorrect Justification
Input
Output
System
Power
Output
Input
Blank
Blank
Blank
Bank 1
Bank 1