Filter
Top Products
INTRODUCTION
4
EnglishDeutschEspañolFrançaisItalianoNederlandsSvenska Dansk
Connection panel
The rear panel provides all input/output connections.
Figure 3
T1 connector
panel
1. IN – Analog input channels 1-3. Accepts XLR balanced cables for microphones, or ¼" TRS balanced or TS
unbalanced cables for high-impedance inputs such as guitars.
2. Preamp OUT – Preamp outputs for channels 1-3. Accepts ¼" TRS balanced or TS unbalanced cables.
3. Line IN – Analog input channels 4/5. Accepts ¼" TRS balanced or TS unbalanced cables for line-level inputs.
Can be used for stereo input signals.
4. Aux Output – User-definable analog output. Can be configured for a pre-fader, post-EQ, and effects, or post-
fader output. Accepts ¼" TRS balanced or TS unbalanced cables.
5. Master Output – User-definable analog output. Can be configured for a pre- or post-Master volume analog
output. Accepts ¼" TRS balanced or TS unbalanced cables.
6. USB port – A USB interface that allows you to connect the T1 to your computer. This feature enables you to
stream audio to/from your computer, update the T1, and back up performance scenes.
7. Power switch – Turns the T1 audio engine on or off.
8. – ToneMatch
TM
port – A digital output used by the L1
TM
model II system. Also delivers power to the T1
audio engine from the L1 model II power stand. Accepts the included ToneMatch
TM
cable.
CAUTION: Although the ToneMatch port accepts a standard RJ-45 connector, DO NOT connect the T1 to a computer
or phone network.
2
3
6
5
7
1
4
8