Filter
Top Products
ii
EnglishDeutschEspañolFrançaisItalianoNederlandsSvenska Dansk
QUICK PATH TO MAKING MUSIC
To get sound right away
1. Remove your new T1 ToneMatch
TM
audio engine from the carrying bag and
remove its protective cover (page 6).
2. Refer to the Quick Setup Guide and
connect your T1 to your L1
TM
system.
3. Make sure the T1 Master volume
control is set to 0 (page 16).
4. Turn on the T1 and then turn on your L1 model II system.
5. Plug your instrument or microphone into the Channel 1
input on the back of the T1 (page 4).
6. Play your instrument or sing into the microphone. Turn the
CH 1 Trim control clockwise until the input signal indica-
tor glows green (page 16).
7. Slowly turn the T1 Master volume control up until it is
approximately in the 12 o’clock position (page 16).
8. Slowly turn the CH 1 Vol control up until you hear your
instrument or microphone (page 16).
IMPORTANT!
Please make sure you read “Optimizing input gain and
output volume” on page 16. This explains how to prop-
erly adjust the input trim, channel volume, and master
volume controls for the best possible sound.
ON
Master
Trim
(CH 1)
Vol (CH 1)