Filter
Top Products
OPERATING INSTRUCTIONS
26
EnglishDeutschEspañolFrançaisItalianoNederlandsSvenska Dansk
Adding reverb
The Reverb function applies a user-adjustable amount of reverb to the selected chan-
nel. To select the type of reverb, see “Selecting a type of reverb” on page 27.
Note: To bypass the Reverb effects, press the Mix button. Press it again to activate.
1. Rotate the Mix button to adjust the desired mix of dry signal to wet signal
(reverb-processed).
2. Rotate the Bright button to equalize the high frequencies of reverb applied to the
selected channel.
Routing input signals to the Aux output
The Aux function allows you to route signals from one of three tap points to the Aux
output for various signal processing, recording, and sound reinforcement applications.
The signal level is adjustable for each of the three available tap points:
Note: To mute the Aux output, press the Level button. Press it again to unmute.
1. Rotate the Level button to adjust the signal level of the selected channel.
2. Rotate the Tap button to scroll through the tap menu and highlight the desired
tap point.
Dry: After Preamp..........The completely dry (no processing) signal is routed directly from the preamp stage.
Pre: With EQ & FX .........The signal is routed from the preamp stage with applied processing.
Post: After Fader...........The signal is routed after the Channel volume control with applied processing.
3. Press the Select button to select the tap point, or press the Cancel button to exit with no change. The name
of the currently selected tap point appears in bold type.
CH 1 Reverb
Mix Bright
50% 50%
CH 1 Aux Output
Level Tap
50% Dry