Filter
Top Products
SYSTEM SETUP
6
EnglishDeutschEspañolFrançaisItalianoNederlandsSvenska Dansk
Removing/attaching the cover
The T1 ToneMatch
TM
audio engine comes out of the carton with a cover installed on the top panel. The cover is
designed to protect the control panel while transporting or storing the audio engine.
To remove the cover:
1. Press and hold the cover latch release button (Figure 5).
2. Slide the cover off the control panel just enough to disengage the alignment tabs.
3. Lift up on the front edge of the cover to remove it.
To attach the cover:
1. Place the cover on the T1.
2. Align the tabs inside the cover with the holes on the front edge of the T1.
3. Slide the cover over the control panel until you hear the click of the latch.
Figure 5
Removing and
attaching the
cover
Alignment tabs
(front edge)
C
over
l
atc
h
release button