Filter
Top Products
21
Using the internal sound generator
Using the internal
sound generator
Specifying the function of the MIDI connectors
If the MIDI OUT/THRU switch on the rear panel is set to [IN1 THRU], MIDI messages received at the MIDI
IN 1 connector will be retransmitted without change from the MIDI OUT 2 connector.
If the SD-80 is operating in USB mode and this switch is set to [IN1 THRU], MIDI messages received at
the MIDI IN 1 connector will be "thru-ed" from the MIDI OUT 2 connector. The MIDI messages that would
normally be output from the computer to the MIDI OUT 1 connector will no longer be output. (They will
not be merged.) In this case, it will not be possible to use USB external output 2 (EDIROL SD-80 MIDI
OUT 2) from the computer.
However, if the SD-80 is operating in MIDI mode and this switch is set to [IN1 THRU], MIDI messages
received at the MIDI IN 1 connector will be "thru-ed" from the MIDI OUT 1 connector as well as being sent
to PART A. In this case, if an external MIDI device sends a dump request to PART B, it will not be
possible to transmit the response.
fig.7-4a
USB mode
THRU function : ON
MIDI OUT 2
USB
MIDI OUT 1
SD-80
MIDI IN 2
MIDI IN 1
Part group A
Part A1 - A16
Part group B
Part B1 - B16
MIDI mode
THRU function : ON
SD-80
USB
MIDI
interface
MIDI OUT 2
MIDI OUT 1
MIDI IN 2
MIDI IN 1
Part group A
Part A1 - A16
Part group B
Part B1 - B16