Filter
Top Products
56
Controlling the SD-80 via MIDI
■ Switching the type of part
Switching the Part Mode in GM2 mode
In GM2, transmit a Bank Select message to switch the Part Mode.
MIDI bank number: CC#00 (MSB) = **
**: The part mode will be switched according to the value that you insert here (decimal).
121 (79H) = Inst part
120 (78H) = Drum part
Switching the Part Mode in Native mode
In Native mode, transmit a Bank Select message to switch the Part mode.
MIDI bank number: CC#00 (MSB) = **
**: The part mode will be switched according to the value that you insert here (decimal).
Inst part: 80 (50H) = Special 1 set
81 (51H) = Special 2 set
96 (60H) = Classical set
97 (61H) = Contemporary set
98 (62H) = Solo set
99 (63H) = Enhanced set
87 (57H) = User set
Drum part: 104 (60H) = Classical set
105 (61H) = Contemporary set
106 (62H) = Solo set
107 (63H) = Enhanced set
86 (56H) = User set
Switching the Part Mode in GS mode
In GS mode, the Inst mode and Drum Part are normally set as follows:
Inst part: Part 1–9, 11–16
Drum part: Part 10
Transmit system exclusive data to switch the Part Mode.
fig.5-2aj
Address: 40 1p 15
p: Part number
Data: 00–02 (00 = Normal, 01 = Drum1, 02 = Drum2)
Checksum: For details on the calculation method, refer to the section “How to calculate the
checksum” within “MIDI Implementation” (MIDIImp_E.pdf) on the included CD-
ROM.
<Example> Switching part 11 to a Drum part
Transmit the following system exclusive data.
fig.5-2bj
After specifying the Part Mode, transmit a Program
Change to part 11 to select a drum set.
F0 41 10 00 48 12 [ 40 1p 15 ] [ ] [ ] F7
address
data
checksum
nn
ss
F0 41 10 00 48 12 [ 40 1A 15 ] [ 02 ] [ 0F ] F7
Part 11
Drum 2
address
data
checksum
checksum