Filter
Top Products
PAGE 208
FIREBALL INSTALLATION & USER’S GUIDE - M22001-01A1
APPENDIX H - REMOTE CONTROL
substitute the appropriate key (i.e., AUX, CBL, DVD, RCV) for the (Auxiliary, VCR,
Cable, Satellite, CD, Amplier, or Tuner) component you are searching for.
Checking the Codes
If you have set up the Remote using the Searching For Your Code procedure, you may
need to nd out which four-digit code is operating your equipment.
For example, to nd out which code is operating your TV:
1. On the Remote, press TV once.
2. Press and hold CODE SET until the LED blinks twice, then release CODE SET .
3. Enter 9 - 9 - 0. The LED will blink twice.
4. To view the code for the rst digit, press 1 once. Wait 3 seconds, count the LED
blinks (e.g., 3 blinks = 3) NOTE: If a code digit is “0”, the LED will not blink.
5. Repeat step 4 three more times for remaining digits. Use 2 for the second digit, 3 for
the third digit, and 4 for the fourth digit.
6. To check for the codes of your other components, repeat steps 1 through 5, but
substitute the appropriate key (i.e., AUX, CBL, DVD, RCV) component you are
checking. As before, write down each four-digit code.