Filter
Top Products
PAGE 72
FIREBALL INSTALLATION & USER’S GUIDE - M22001-01A1
CHAPTER 3 - GETTING STARTED
If it nds new CDs, FireBall will initiate a connection to the CDDB database on the
Internet to get data for your new CD.
If you remove discs and put others back in the same slot, you will have to manually
initiate a detailed lookup such as lookup range or lookup all in the changer
management section in SETUP. The GET MUSIC INFO screen will report the status
of the lookup progress until it is complete, or you press STOP to cancel the operation.
Adding or Removing Changers
If a changer has been attached to FireBall, removed, and then re-attached, FireBall
will assume that the disc collection has not changed. If you have made disc changes
to FireBall, you should manually go to the changer management section in SETUP
and check all discs to insure that all discs are recognized.
If a changer has been attached to FireBall, but then is completely removed, the titles
for CDs in that changer and the playlists still appear in the Guide. However, unlike
MP3 music which is located on the FireBall, the CDs and playlists from this particular
changer are not available for play and are indicated by a questin mark ‘?’ in the Title's
icon..
If supported changers are not found, you will be asked if you want to disconnnect the
changer permanantly, try again to locate it, or ignore the fact that it was not found.
2
Networked FireBalls: Music from at-
tached changers is available for play
on the FireBall which is physically con-
nected to the changer.
Unlike MP3 music, CDs are not
available for play to or from remote
FireBalls or MP-100 Players attached
to a home network.