120
MR-8HD Owner’s Manual (Part editing)
9) Rotate the [MENU/ENTER] knob to move the
cursor to "[ENTER]" on the screen, and press the
[MENU/ENTER] knob.
The display shows "Please Wait", immediately
followed by "Completed" when the MR-8HD
completes the move operation.
<Note>:
You cannot select the same track(s)
for the move source and destination.
<Note>:
If you are not satisfied with the re-
sult, press the [UNDO/REDO] key to undo
the operation (see page 111).
10) Press the [MENU/ENTER] knob.
The display now returns to the part edit menu
screen, where “Move Part >” is highlighted.
11) Press the [STOP] key to exit the menu mode.
8) Rotate the [MENU/ENTER] knob to select the
destination track(s), and press the
[MENU/ENTER] knob.
The display returns to the screen where
"Dest. Track = *" is highlighted.
If you want to cancel the move operation, move
the cursor to "[CANCEL]" on the screen, and
press the [MENU/ENTER] knob.
