Filter
Top Products
39
MR-8HD/CD Owner’s Manual (Basic operations)
You can simultaneously record up to four tracks. See page 34 for the available combinations of
four recording tracks. The following describes the procedure for recording different sound sources
simultaneously to tracks 1 through 4. You can make four-track simultaneous recording with any
available track combination in the same manner.
1) Connect the following sound sources to the
[INPUT A] through [INPUT D] channels.
[INPUT A] -> Electric guitar
[INPUT B] -> Electric bass
[INPUT C] -> Microphone (vocal)
[INPUT D] -> Drum machine
Preparation for recording
MIN MAX
100
LR
100
LR
100
LRRL
MIN
MAX
LINE MIC LINE MIC LINE MIC LINE MIC
REC SELECT
010
1
2
3
4
5/6 MASTER
MAX
MAX
MIN
MIN
7/8
LOCATE REC END
A-B PLAY
LOCATE ABS ZERO
PLAYSTOP
RECORD
REWIND F FWD
GUIDE
RHYTHM
CONTRAST
1-8 >
SONG
NEW
1-6 > 7/8
1-4 > 5/6 STEREO
WAV FILE
BOUNCE
POWERFUL
MASTERING
B / OUT
A / IN
LOCATE
STOREPLAY MODEAUTO PUNCH
NATURAL BRIGHT
TIME BASE
SELECT
UNDO/REDO
7/8 >
MENU / ENTER
SIMULATION
DYNAMIC CONDENSER TUBE
MIC
PAN
EFFECT
REVERB / DELAY TIME
HALL
ROOM
PLATE DELAY
PHONES VOL
L
STEREO OUT
R
2
PHONES
1
MAXMIN
BAL
BALBAL
TRIM
UNBAL
PEAK
TRIM
UNBAL
PEAK
TRIM
UNBAL
PEAK
PEAK
DISTORTION
GUITAR
/GUITAR
INPUT A SELECT
INSERT
BAL
UNBAL
TRIM
INPUT A
INPUT B INPUT C INPUT D
ON/
OFF
POWER
ABC1 DEF2 GHI3
JKL4 MNO5
PQR6 STU7 VWX8 YZ9 +-_0
DELETE
TO STEREO BUSS
EFFECT SEND
ON/
OFF
ON/
OFF
ON/
OFF
60'S COMBO
US METAL
BRIT STACK
AMP
SIMULATION
INPUT A
INPUT A SEL
MIC/LINE
GTR CLEAN
GTR DIST
1
4
5
6
3
7
8
9
1
2
4 10
1 1
6
<Note>:
You can apply the amp simulation
as insert effects when the [
INPUT A SELECT
]
switch is set to "
GTR DIST
" (see page 58).
<Note>:
If you connect a condenser micro-
phone to the [
BAL
] XLR connector of the [
IN-
PUT C
] channel, you can supply the phan-
tom power to the microphone (see page
128).
2) Set the [INPUT A SELECT] switch to "GTR DIST".
You can add distortion of the internal effects
to your guitar sound.
3) Press the [REC SELECT] key for tracks 1 through
4.
Tracks 1 through 4 are record armed and the
[REC SELECT] keys for tracks 1 through 4 start
flashing.
On the home screen, track numbers "1"
through "4" changes to "A" through "D"
respectively, showing that each input is
assigned to the appropriate track.
The remaining time of the hard disk is shown.
4) Set the track faders 1 through 4 and [MASTER]
fader to the nominal position (marked by
).
Raising these faders allows you to monitor the
input sound. If these faders are not raised, you
cannot monitor the sound via headphones.
Recording onto four tracks simultaneously