Filter
Top Products
R MODE
Record Mode Menu Display
En.18
ENGLISH
Recording Mode Menu
This menu will not be available if ‘Enable Configuration changes in DRM’ was set to ‘No’
when the configuration file was defined in FlashMic Manager.
The Recording Mode menu permits selection of an alternative digital recording format to
that determined by the currently selected preset.
A total of six recording formats are available within FlashMic; two file formats at each of
three sample rates. The formats are:
FILE TYPE
SAMPLE
RATE
DISPLAY
MAXIMUM
RECORDING TIME
BWF files (uncompressed) 48kHz
LIN48K
3hr
BWF files (uncompressed) 44.1kHz
LIN44K
3hr 15min
BWF files (uncompressed) 32kHz
LIN32K
4hr 30min
MPEG1 (Layer 2) files
48kHz
MP48K
12hr 15min
MPEG1 (Layer 2) files 44.1kHz
MP44K
14hr 40min
MPEG1 (Layer 2) files 32kHz
MP32K
18hr 25min
The choice of recording mode will usually be determined by the onward programme
production chain.
To enter the Recording Mode Menu, enter MENU mode by pressing the M/STOP button,
and then make SHORT DOWN TURNs of the jogswitch until the display shows R MODE.
Select this with a SHORT PRESS, and the display will show the name of the currently selected
recording mode, as listed above. To select a different recording mode, make SHORT UP or
DOWN TURNs. The display will show the names of the alternative modes.
When the required recording mode is displayed, a SHORT PRESS on the jogswitch will
select it. The display will then show OK to confirm.
The recording mode selected will be that used for subsequent recordings until a different
recording mode or preset is selected.
Note that any recordings already in the FlashMic’s memory will remain at whatever mode
was applicable when they were made.