Filter
Top Products
En.28
ENGLISH
Preset Configuration
Record Mode ‡ – this drop-down box lets you determine the file type and sample rate from
6 options:
RECORD
MODE
FILE TYPE
SAMPLE
RATE
MAXIMUM
RECORDING TIME
LIN48K BWF files (uncompressed) 48kHz 3hr
LIN44K BWF files (uncompressed) 44.1kHz 3hr 15min
LIN32K
BWF files (uncompressed) 32kHz 4hr 30min
MP48K MPEG1 (Layer 2) files 48kHz 12hr 15min
MP44K MPEG1 (Layer 2) files 44.1kHz 14hr 40min
LIN32K MPEG1 (Layer 2) files 32kHz 18hr 25min
Audio Format – confirms selected audio algorithm
Sample Rate – confirms selected sample rate
Encoded BitRate – confirms effective bitrate of data being written into memory
PreRecord Buffer ‡ – drop-down box for setting the duration of the FlashMic’s pre-record
buffer in 1 second increments from zero (off) to 10 seconds. (Set to OFF in example) See
section on PreRecord Buffer, page 36 for more information.
Record Volume/AGC ‡ – If the AGC box is checked (as in this case), the Record Volume
drop down box will be greyed-out. With this setting, the AGC circuit is turned on, and no
fixed record level is set.
If the AGC box is unchecked, the Record Volume drop-down box permits setting of the
record level in 5dB increments from 5dB to 40dB.
See Adjusting Record Level, page 13 for more information.
High Pass Filter ‡ – FlashMic includes a 100Hz 12dB/octave high-pass filter which can
be switched in and out.
Backlight ‡ – the display panel backlight in FlashMic can be set to be permanently on
or off, or to “Energy-Save mode”, where the backlight illuminates for a short period when
a button is pressed. The battery life will be noticeably shortened if the backlight is set to
“Always On”.