Filter
Top Products
Basic Controls P. 21
• The LED Indicator on the EFFECT and CHORUS buttons will be on only when the active Priority
Part has these effects turned on.
Example
Assume that your CP is set up according to the following chart:
SOLO RIGHT1 RIGHT 2 LEFT INDICATOR
Part Inactive Active Inactive Active
Effect On On Off On On
If you then select a different sound for RIGHT1, the Effect setting for the SOLO, RIGHT2, LEFT will
be turned off automatically. This is because RIGHT1 is the Priority Part (note that the SOLO Part is
NOT the Priority Part because it was inactive).
The chart would now look like this:
SOLO RIGHT1 RIGHT 2 LEFT INDICATOR
Part Inactive Active Inactive Active
Effect Off On Off Off On
Even if you now assign a new sound to the SOLO Part, the Effect settings for the other Parts won’t
change, because SOLO is still inactive, so therefore would not have priority.
Once you make the SOLO Part active, however, it would now be considered the Priority Part. The
Effect settings for the other Parts will again be turned off. The Indicator light on the EFFECT
button will now reflect the Effect status for the sound assigned to SOLO.
SOLO RIGHT1 RIGHT 2 LEFT INDICATOR
Part Active Active Inactive Active
Effect Off Off Off Off Off
At this point, if the Effect that has been called up along with the SOLO sound is one that you’d like
to use for the other Parts, simply select Effect On in the LCD display for those Parts.