Filter
Top Products
14
Step 4. To connect AC modules in different rows, use the extension cable.
(Refer to the next page under Cable Usages According to AC Junction Box Locations)
Step 5. Remove the dust cover of the female connector of the last AC module and seal with end cap to ensure
waterproofing and dust prevention. Insert the end cap into the trunk male connector in the arrow direction
until you hear a clicking sound. Seal the end part by referring to the following drawing.
Step 6. Check the cables to verify they have not been pulled too tight or are hanging too loose. If necessary, fixate
them using the cable fixing holes on PV module frame with fixing holders, such as cable ties, so that the
cables do not touch the ground.
Trunk connector and end cap serve to prevent collection of dust and waterproof functions.
Checking Accessory
Male end cap Female end cap
Checking the Accessories
Female + Female
extension cable
Male + Male
extension cable
Female + Male
extension cable
If trunk female
connector is the end part
If trunk male
connector is the end part
‹
‹