Filter
Top Products
105
RSM 191
Technical Data
Acoustical operating principle............ M: Pressure gradient/interference
transducer
S: Pressure gradient transducer
Directional pattern.............................................................................M: Lobe-shaped
S: Figure-8
Frequency range..................................................................................20 Hz...20 kHz
Sensitivity at 1 kHz into 1 kohm...........................................................23 mV/Pa
Rated impedance................................................................................................ 50 ohms
Rated load impedance..............................................................................1000 ohms
Signal-to-noise ratio, CCIR
1)
(rel. 94dB SPL)..............................69/63 dB
2)
Signal-to-noise ratio, A-weighted
1)
(rel. 94dB SPL)...............78/72 dB
2)
Equivalent noise level, CCIR
1)
................................................................25/31 dB
2)
Equivalent noise level, A-weighted
1)
............................................16/22 dB-A
2)
Maximum SPL for THD 0.5%
3)
..................................................................134 dB
Maximum SPL for THD 0.5% with preattenuation
3)
...................144 dB
Maximum output voltage...........................................................................2540 mV
Supply voltage (P48, IEC61938)..........................................2 x 48 V ± 4 V
Current consumption (P48, IEC61938).....................................2 x 1.9 mA
Matching connector.....................................................................................2 x XLR3F
Weight.............................................................................................................................170 g
Diameter......................................................................................................................30 mm
Length........................................................................................................................ 212 mm
an excellent impulse response, reproducing all
transient phenomena in music and speech
without coloration. The entire internal con-
struction is decoupled from the housing to
avoid structure borne and handling noise.
Electrical features
The output signals of the included matrix am-
plifier are in either MS or XY format. The small
capsules are mounted in close proximity to en-
sure transparent and coloration-free stereo
sound with excellent mono-compatibility. The
stereo acceptance angle is variable and con-
trolled remotely.
Filter and attenuation
For the handling of very high
sound pressure levels, a 10dB
attenuation can be switched
ON to avoid overloading of the
following equipment.
To suppress structure borne
noise, a high-pass filter in the
matrix box provides cutoff fre-
quencies of 40Hz, 80 Hz, and
200 Hz.
Battery supply
The RSM191 system is fed
from either 2x P48 phantom
power or from a 9 V battery in-
side the matrix box.
One alkaline battery provides
8 hours of operation.
1)
according to IEC 60268-1; CCIR-weighting acccording to CCIR 468-3, quasi peak; A-weighting according to IEC 61672-1, RMS
2)
M/S
3)
measured as equivalent el. input signal