Filter
Top Products
147
Adapter Cables
Adapter Cable AC 29
Y-cable with XLR5F connector and two
unbalanced 6.3mm mono jacks, with
blocking condensers. It is used to con-
nect the XLR5 output of the MTX191
(MTX 191A see AC 27) matrix amplifier
and KU100 microphone to units with
6.3 mm monojack inputs.
AC29 (0.3 m).....................Cat. No. 006604
Other cable lengths are available upon request!
Adapter Cable AC 30
Y-cable, 5 m long, to connect two active
capsules, e.g. AK 20 and AK 40 as MS
stereo couple directly to the MTX 191(A)
matrix amplifier. XY or MS signals are
then available at the XLR 5 output con-
nector of the MTX 191 (A). The recording
angle is electrically remote controlled.
KM 100 output stages are not required.
Markings: yellow for channel 1 (cardio-
id), red for channel 2 (figure-8).
AC 30 (5 m) ........................Cat. No. 008418
Adapter Cable AC 27
Y-cable with XLR5F connector and two
unbalanced 6.3 mm mono jacks. It is
used to connect XLR5 outputs of the
BS48 i-2 power supply or the
MTX 191 A matrix amplifier to units with
6.3 mm monojack inputs. Designed for
all microphones, excluding KM 100 Sys-
tem and GFM 132.
AC27 (0.3 m).....................Cat. No. 006602
Adapter Cable AC28
Y-cable with XLR5F connector and two
unbalanced 6.3 mm mono jacks. It is
used to connect the XLR5 output of the
BS 48 i-2 power supply to units with
6.3 mm monojack inputs. Designed only
for KM 100 System GFM 132.
AC28 (0.3 m).....................Cat. No. 006603
Cable Material for General Use
Conductor resistance................ < 240 ohm/km
Insulation resistance..............> 20 Mohm x km
Capacitance core/core ....... 105 nF/km (1kHz)
Test voltage core/core...........................1.2 kV
Test voltage core/shield .......................0.6 kV
Temperature range ................... –20° to +70°C
K 3 x 0,08 ............blk ........Cat. No. 062728
Conductor resistance.................< 96 ohms/km
Insulation resistance............ > 20 Mohms x km
Capacitance core/core ....... 135 nF/km (1kHz)
Test voltage core/core...........................1.2 kV
Test voltage core/shield .......................0.6 kV
Temperature range ................... –20° to +70°C
K 3 x 0,2 .............. blk........Cat. No. 062700
Our cable material has been developed by Neumann and is exclu-
sively produced for Neumann by highly qualified manufacturers. All
microphone cables have a counter wound double helix copper
shielding, assuring a particularly high degree of coverage (95%).
HF rejection is exceptionally good, flexibility of the cable excellent.
All prices on request.
Cable Material K 3 x 0,08
• 3 conductors 0.08 mm² copper wire 41 x 0.05 mm²
• Insulation: special thermoplastic
• Shielding: 2 layers of counter wound bare copper wire
• Jacket: special PVC matte charcoal-gray and round
• Printing “Georg Neumann GmbH Berlin - Made in Germany”
• Overall diameter: 3.4 mm
Cable Material K 3 x 0,2
• 3 conductors 0.2 mm² copper wire 102 x 0.05 mm²
• Insulation: special thermoplastic
• Shielding: 2 layers of counterwound bare copper wire
• Jacket: special pvc matte charcoal-grey and round
• Printing “Georg Neumann GmbH Berlin - Made in Germany”
• Overall diameter: 5.0 mm