Filter
Top Products
135
Floor Stands, Booms and Shock Mount
Shock Mount Z 26 mt
The Z 26 rubber shock mount is inserted
between the stand and the swivel mount
to avoid the transmission of structure-
borne noise. It has a 1/2" threaded stud
and a 5/8"-27 female thread to attach to
tripods. Included is a thread adapter for
1/2" and 3/8" studs.
Z 26 mt ................ blk ........ Cat. No. 006207
Stand Extensions STV 4/20/40/60
The STV... stand extensions are screwed
between microphone stands (for exam-
ple MF 4, MF5) and swivel mounts (for
example SG 21/17 mt).
Length 40, 200, 400 or 600 mm.
Ø 19 mm.
STV 4 .................... blk ........Cat. No. 006190
STV 20 ................. blk ........Cat. No. 006187
STV 40 ................. blk ........Cat. No. 006188
STV 60 ................. blk ........Cat. No. 006189
Goosenecks
Gooseneck SMK 8 i
The SMK 8 i gooseneck is 360 mm long
and serves as electrical and mechanical
connection of a microphone with XLR 3
connector. A counter nut secures the
microphone against rattle and – to a cer-
tain extent – against theft. The cable
comes out at the side, just above the
bottom thread. Cable length 4.5 m, ca-
ble connector XLR 3 M. The gooseneck
has a 5/8"-27 female thread, plus a
thread adapter to connect to 1/2" and
3/8" stands.
SMK 8 i ................ blk ........ Cat. No. 006181
Gooseneck SMK100 KA
The SMK 100KA for the KM 100 system
is used to assemble particularly small
table microphones, for example on an
MF 2 table stand. The gooseneck is only
8 mm in diameter. It has a 5/8"-27 fe-
male thread, plus a thread adapter to
connect to 1/2" and 3/8" stands. The
cable is incorporated in the gooseneck
and emerges at the rear. It terminates
with a ring contact adapter fitting onto
the KM100(F) output stages. Goose-
neck length 160 mm. Cable length 2.5 m.
SMK100 KA ........ blk ........ Cat. No. 008413
Double Gooseneck SMK 100-2 KA
Gosseneck for directly mounting two
active capsules of the KM 100 system,
making a particularly small table micro-
phone. Both goosenecks are only 8 mm
in diameter. The bottom has a 5/8"-27
female thread, plus a thread adapter to
connect to 1/2" and 3/8" stands. The
cables incorporated in the goosenecks
emerge at the rear. They terminate with a
ring contact adapter fitting onto the
KM100 (F) output stages. Gooseneck
length 160 mm. Cable length 2.5 m.
SMK100-2 KA..... blk ........ Cat. No. 008414