Filter
Top Products
55
Record and Playback Your Performance
Re-recording a Performance Saved on
Floppy Disk
A song saved on floppy disk can be loaded into the AT-5, and you can then
re-record the performances.
1. Into the disk drive, insert the floppy disk that contains the
performance data.
2. Press the Select [-] [+] buttons to select the performance data
that you wish to load into the AT-5.
3. Press the [Rec] button to enter record-ready mode.
The selected performance data will be loaded.
The [Rec] button indicator will light, and the [Play/Stop] button indicator
will blink.
4. Make the panel settings that you wish to record.
5. Press the [Play/Stop] button to begin recording.
When you press the [Play/Stop] button, the metronome will play two
measures (bars) of count-in before recording begins.
As you record, the performance data that was loaded into the AT-5 will play
back.
Your own performance (on the upper and lower parts) will be recorded on
top of the performance data that you’ve loaded.
If the loaded performance data contains upper part and/or lower part
performances, that performance data will be erased and replaced by your
new performance.
6. Press the [Play/Stop] button to stop recording.
Using Song with a Different Tempo
Than That of the Performance Song
1.
Into the disk drive, insert the floppy disk that contains the
performance data.
2. Press the Select [-] [+] buttons to select the performance data
that you wish to change the tempo.
3. Determine the tempo with the Tempo [ ] and [ ]
buttons.
4. Hold down the [Reset] button and press the [Rec] button.
The song’s tempo changes.
You can re-record the bass
performance.
For details refer to “Reails refee.