Filter
Top Products
50
Recording Your Performance
Overdubbing
1. Hold down the [Play/Stop] button and press the [Bwd] button.
You’ll return to the beginning of the recorded performance.
MEMO
You can also return to the beginning of the recorded performance by holding down the [Bwd] button.
2. Press the [Rec] button.
The [Rec] button will light.
If you decide to cancel recording, press the [Rec] button once again.
3. Press a track buttons ([Accomp], [User], [Left], [Right]) so the indicator for the track you want to record is blinking.
4. Press the [Play/Stop] button.
A two-measure count will be heard (as the measure number, “-2” is shown, then “-1”), and then recording will begin.
When recording begins, the [Rec] button and the [Play/Stop] button will light.
MEMO
If desired, you can start recording by playing the keyboard while the HPi-6F is in recording-standby mode; recording will begin the instant you play
the keyboard. In this case, no count will be heard.
5. Press the [Play/Stop] button.
Recording will stop.
MEMO
When you overdub-record without erasing the previously recorded performance, the song’s tempo and time signature will remain as they were
initially recorded.
About re-recording
If you select a track that already contains a previous recording, your new performance will be stored there anyway, overwriting the existing data. This
means that the previously recorded performance will be lost.
Performance recorded
rst remains.
Replaced by performance
recorded second time.
First recording
Second recording
MEMO
If you want to record a new performance, you must rst erase the previously recorded performance (p. 46).