Filter
Top Products
58
Making Various Settings
The RG-1F/RG-3F features a built-in, four-band digital equalizer.
You can also save up to four sets of equalization settings, each
one containing the settings you’ve chosen for achieving a
desired tonal quality.
An equalizer boosts or cuts specific sound pitches (frequency
ranges) to adjust the sound balance.
For example, you can boost the highs to get a crisper sound, or
boost the low end for a more powerful sound.
You can also adjust the sound to compensate for the acoustical
characteristics of the performance space.
If raising the values for separate frequencies causes the sound to
distort, you can use the “Master Gain” to control such distortion.
You can save this setting in the RG-1F/RG-3F’s memory
using the Memory Backup function (p. 72).
1.
Press the [Piano Designer] button so the indicator is lit.
2.
Use the [
▲
] [
▼
] buttons to select “3. Equalizer.”
3.
Press the [Enter] button.
fig.d-Equalizer.eps
4.
Press the [+] button or [–] button to select the equalizer
set number.
If you select a setting other than “Off,” the [Enter] button
indicator will blink.
fig.d-Equalizer1.eps
5.
Press the [Enter] button.
The setting screen for the equalizer appears.
fig.d-Equalizer2.eps
6.
Use the [
▲
] [
▼
] buttons to select the item you want to
set.
7.
Press the [+] or [–] button to change the value.
8.
Press the [Piano Designer] button several times to make
the indicator go dark.
Equalizer Settings
Adjusting the Sound to Achieve the Preferred
Tone Quality (Equalizer)
Value
Off, Set1–Set4
Parameter
Value Description
Low Gain
-12 –
+12dB
Adjusts the level of the low
frequency range.
Low Freq
100 –
1.0k (Hz)
Frequency point in the low
frequency range. Generally,
this changes the level at and
below this frequency.
Lo Mid
Gain
-12 –
+12dB
Adjusts the level of the low
frequency range to
midrange.
Lo Mid
Freq
16 –
16.0k (Hz)
Frequency point in the low
frequency range to
midrange. This changes the
level of the specified
bandwidth centered on this
frequency.
Lo Mid Q
0.5, 1.0,
2.0, 4.0,
8.0
Changes the bandwidth of
the low frequency range to
midrange.
The bandwidth affected by
the controls narrows as the
value increases.
Hi Mid
Gain
-12 –
+12dB
Adjusts the level of the mid-
to high-frequency range.
Hi Mid
Freq
16 –
16.0k (Hz)
Frequency point in the mid-
to high-frequency range. This
changes the level of the
specified bandwidth
centered on this frequency.
Hi Mid Q
0.5, 1.0,
2.0, 4.0,
8.0
Changes the bandwidth of
the mid- to high-frequency
range.
The bandwidth affected by
the controls narrows as the
value increases.
High Gain
-12 –
+12dB
Adjusts the level of the high
frequency range.
High Freq
1.25k –
16.0k (Hz)
Frequency point in the high
frequency range. Generally,
this changes the level at and
over this frequency.
Master
Gain
-12 –
+12dB
You can temper the
distortion in the sound by
lowering the level. Raising
the level too much may cause
the sound to become
distorted.
RG-1F3F_e.book 58 ページ ２０１０年１月１９日 火曜日 午前９時１分