Filter
Top Products
71
Making Various Settings
You can change the pitch of the Tone 2 in Dual Performance (p.
23) and Left-hand Tone in Split Performance (p. 25) an octave at a
time.
Altering the pitch in one-octave units in this way is called “Octave
Shift.”
For example, you can raise the pitch of the Left-hand Tone to the
same pitch of the Right-hand Tone in Split Performance.
1.
Press the [Piano Designer] button so the indicator is lit.
2.
Use the [
▲
] [
▼
] buttons to select “9. Function.”
3.
Press the [Enter] button.
4.
Use the [
▲
] [
▼
] buttons to select “Octave Shift.”
fig.d-Func-Octave.eps
5.
Press the [+] or [–] button to change the value.
6.
Press the [Piano Designer] button several times to make
the indicator go dark.
In some cases when you connect USB memory to the external
memory connector, it may take some time for data to be read, or
data might not be read correctly.
If so, you may be able to solve the problem by changing the USB
memory communication setting.
* Normally, there’s no need to change this setting.
1.
Press the [Piano Designer] button so the indicator is lit.
2.
Use the [
▲
] [
▼
] buttons to select “9. Function.”
3.
Press the [Enter] button.
4.
Use the [
▲
] [
▼
] buttons to select “EXT Memory Mode.”
fig.d-Func-EXTMem.eps
5.
Press the [+] or [–] button to change the value.
6.
Press the [Piano Designer] button several times to make
the indicator go dark.
• You must turn the power off, then on again in order to apply
the changed setting.
• This setting is remembered even when the power is turned
off.
Changing the Pitch of the Tone in Octave Steps
(Octave Shift)
Value
-2 – 0 – +2
Switching the USB Memory Communication
Settings (External Memory Mode)
Value
1, 2
RG-1F3F_e.book 71 ページ ２０１０年１月１９日 火曜日 午前９時１分