Filter
Top Products
64
Various Settings
In “Function mode” you can make various settings for
performance and recording.
1.
Hold down the [Brilliance] button and press
the [3D] button.
The [Brilliance] button and [3D] button will light.
The display will indicate “Fnc” and you’ll be in Function
mode.
fig.d-Fnc.eps
2.
Press one of the blinking buttons to select the
setting you want to change.
The display shows the name of the setting while you hold
down the button. The value of the setting will appear
when you release the button.
3.
Use the [-] [+] buttons to change the setting.
4.
If you want to change a different setting, select
the setting you want to change by pressing
one of the buttons that were blinking before
step 2.
5.
Press the [Brilliance] button or the [3D] button
to exit Function mode.
The button indicators will return to their former state.
The settings you change will return to their original
state when you turn off the power (except the USB
Driver and the Ext. Memory mode settings.) If you
want your changes to be retained even after the
power has been turned off, carry out the Memory
Backup procedure (p. 78) to save the settings.
Basic Operation in Function
Mode
NOTE
Button
Function Page
[Reverb]
3D Mode
p. 65
[Transpose]
Transpose Mode
p. 66
[Split]
Octave Shift
p. 66
[Twin Piano]
(&[-][+])
Damper Pedal Part
p. 67
Center Pedal Function
p. 67
Left Pedal Function
p. 67
[Piano]
Master Tuning
p. 68
[E.Piano]
Temperament
p. 68
[Organ]
Stretched Tuning
p. 69
[Strings]
Damper Resonance
p. 70
[Voice]
String Resonance
p. 70
[Others]
Key Off Resonance
p. 70
[Metronome]
Metronome Sound
p. 71
[Tempo]
(&[-][+])
Countdown
p. 71
Countdown Sound
p. 71
Countdown Part
p. 72
HP203_e.book 64 ページ ２００７年４月１２日 木曜日 午前１０時５分