Filter
Top Products
78
Various Settings
You can connect a commercially available USB CD drive to
the HP203, and play back separately sold CD-ROMs created
for the VIMA (VIMA TUNES).
Songs on VIMA CD-ROM (VIMA TUNES) are programmed
with “recommended tones” suitable for each song.
When you select a song from a VIMA CD-ROM (VIMA
TUNES), recommended tones will be assigned to the HP203’s
[Strings], [Voice], and [Others] tone buttons, and these three
tone buttons will blink.
When you press a flashing Tone button, the recommended
tone is then selected, enabling you to perform the selected
song using a tone matched to that song as it plays back.
You can set the HP203 so that the recommended tones are
automatically assigned or not assigned.
1.
Hold down the [Brilliance] button and press
the [3D] button.
The display will indicate “Fnc” and you’ll be in Function
mode.
2.
Hold down the Track [Accomp] button and use
the [-] [+] buttons to make the display indicate
“rtn.”
When you take your finger off the button, the display
will indicate the value of the setting.
3.
Use the [-] [+] buttons to change the setting.
This is set to “On” at the factory.
Normally, the settings of the various variations will revert to
their default values when the power is turned off. However,
you can specify that the various settings will be remembered
even when the power is turned off.
This function is called “Memory Backup.”
1.
Hold down the [Brilliance] button and press
the [3D] button.
The display will indicate “Fnc” and you’ll be in Function
mode.
fig.d-Fnc.eps
2.
Press the [Left] button.
The display will indicate “buP” and the [ ] button
will blink.
3.
Press the [] button.
The display will indicate “Sur,” and the [ ] button
and [ ] button will blink.
If you decide not to save the settings, press the
[ ] button.
4.
To save the settings, press the [] button.
Never turn off the power while “buP” is blinking in
the display.
When the memory backup has been completed, the
display will indicate “Fnc.”
fig.d-Fnc.eps
For details on the settings stored by the Memory
Backup operation, refer to p. 96.
Switching VIMA TUNES Recommended
Tones (Recommended Tone)
Setting Explanation
When you select a song from a VIMA CD-ROM
(VIMA TUNES), recommended tones will
automatically be assigned to the HP203’s [Strings],
[Voice], and [Others] tone buttons.
The recommended tones are not used, and only the
HP203’s internal tones can be selected.
Remembering the Settings
(Memory Backup)
NOTE
HP203_e.book 78 ページ ２００７年４月１２日 木曜日 午前１０時５分