Filter
Top Products
73
Various Settings
Here you can make various MIDI-related settings for the
HP203.
For more about MIDI, refer to “Connecting to MIDI Devices”
(p. 82).
When you have a MIDI sequencer connected, set this
parameter to Local Off.
Since the Thru function of your sequencer will normally be
turned on, notes played on the keyboard or played back by
the recorder will be transmitted to the sound generator by the
two routes (1) and (2) shown in the illustration, causing notes
to be sounded in duplicate or to be cut off unnaturally. To
prevent this, the setting called “Local Off” is used to disconnect
the route in (1).
fig.LocalCntr.j
Local On:
The keyboard and recorder are connected to
the internal sound generator.
fig.LocalOn.j
Local Off:
The keyboard and recorder are not connected
to the internal sound generator. No sound will be produced by
the keyboard when it is played.
fig.LocalOff.j
1.
Hold down the [Brilliance] button and press
the [3D] button.
The display will indicate “Fnc” and you’ll be in Function
mode.
2.
Hold down the Track [Accomp] button and use
the [-] [+] buttons to make the display indicate
“L.Ct.”
When you take your finger off the button, the display
will indicate the value of the setting.
3.
Use the [-] [+] buttons to change the setting.
When connecting a unit in the Roland MT series, you
don’t need to switch off Local Control. MT units
transmit Local Off messages when their power is
switched on. If you first switch on the HP203, then
the MT-series device, Local Control is automatically
switched off on the HP203.
MIDI Settings
Preventing Doubled Notes When
Connected to a Sequencer (Local Control)
(1)
MIDI
MIDI
MIDI
MIDI
(2)
IN
IN
OUT
OUT
Sequencer
Memory
Sound
Generator
Each note played is sounded twice
Soft Thru On
Local On
Local On
Sound is emitted
Sound Generator
Local Off
No sound produced
Sound Generator
Setting
Explanation
The Local Control is set to On.
The keyboard and recorder are connected to the
internal sound generator.
The Local Control is set to Off.
The keyboard and recorder are not connected to the
internal sound generator. Playing the keyboard or
playing back a song will not produce sound.
NOTE
HP203_e.book 73 ページ ２００７年４月１２日 木曜日 午前１０時５分