Filter
Top Products
21
Applying Effects to the Sound
fig.05-15(LCD_PatchEditControl/Bend)
Patch Controls determine how the Control Functions actually
affect the Upper and the Lower Tones.
Bend (Bender Range)
This sets the variable range of the pitch change caused by moving
the Bender lever fight and left. The variable range set here may
result differently depending on the setting of the Tone Parameter
Bender Mode (p. 60).
Value:
0–12
AfterPB (Aftertouch, Pitch Bender)
This sets the sensitivity of the aftertouch effect on pitch. Higher
values mean higher sensitivity. A Minus setting decreases the pitch, and a plus setting increases it.
Value:
-12–+12
Hold (Hold Mode)
This selects the Tone that on the Pedal Hold effect. When the
Key
mode
is
Whole
, Pedal Hold always works whichever of the above
three modes may be selected.
Value:
U, L, UL
Time (Portamento Time)
This sets the portamento time from one note to another. Higher values make the time longer.
Value:
0–100
Mode (Portamento Mode)
This selects the Tone that should take on the Portamento effect.
When the
Key Mode
is
Whole
, Portamento always works
whichever of the above three modes may be selected.
Value:
U, L, UL
* Even when Portamento is set to ON, the Portamento ON/OFF message
sent from an external device can change the settings of Portamento.
CONTROL
Display Function
U Works on the Upper Tone.
L Works on the Lower Tone.
UL Works on the both Tones.
Display Function
U Works on the Upper Tone.
L Works on the Lower Tone.
UL Works on the both Tones.
vc1_for_XT_e1 21 ページ ２００５年３月８日 火曜日 午後１２時５５分