Filter
Top Products
61
Tone Parameters
TVF
fig.09-30(LCD_TVF/TVF)
fig.09-31e(CutoffFrequency)
Freq (Cutoff Frequency)
Sets the cutoff point of the TVF. As you lower the value, higher
frequencies are removed and the waveform gradually become an
approximation of a sine wave, then the sound will finally fade
out.
Value:
0–100
TVF (Time Variant Filter)
Bender Mode Example:
• If the Bender range is set to 12 (1 octave), and the Keyfollow (Pitch) of WG is set to 2, the
maximum pitch change caused by moving the Bender Lever is 2 octaves.
• When the Keyfollow (Pitch) of WG is set to zero, there is no pitch change caused by the
Bender lever.
Frequency
Level
Cutoff Point Frequency
Level
Cutoff Point Frequency
Level
Cutoff Point Frequency
Level
0
100
Value
vc1_for_XT_e1 61 ページ ２００５年３月８日 火曜日 午後１２時５５分